How To Remove A Screen Protector From Your Phone

How to remove a screen protector from your phone. Use a hair dryer to quickly dry your screen protector. Start at the top right corner of your phone and slowly remove the screen protector glass away from the screen with the toothpick. If you want to use it again, set it. The screen protector on your phone is a simple, sticky, and useful material that will help prevent the screen from getting scratched.

Use dish soap to lightly clean the sticky side. Dampen it with water and remove any visible dirt and grime. Place the sticky side of the screen protector under cool running water. Press on it gently to push all the air out of the tape.

Stick the rolls to the top side of your screen protector. If you have a soft, flexible screen protector you can alternatively apply a piece of duct tape to the corner and lift. Loop a piece of adhesive tape around your fingers and dab it against the sticky part of your screen protector. Using scotch tape, remove any excess dust.

Wash your hands thoroughly to rid them of natural oils that could smudge your screen protector. You may want to try to use a piece of strong duct tape to lift the screen protector; Peel the protector off slowly and remove it from your phone. While removing the protector, you should also remember that the idea is protecting your screen from getting scratches during the process.

You can use a hairdryer if you want to speed up the process. Learn the best ways on how to clean your iphone screen or tempered glass using a microfiber cloth, dish soap, and other products. Push a credit card gently along the length of the display to remove the screen protector. Any debris, dust, or grease on your hands can transfer to the screen or the screen protector’s bottom side.

Let your screen protector dry. The tape will be used to clean off this dust. Begin peeling the protector up along the sides. If you can’t get your fingernail underneath it, try a toothpick, credit card or guitar pick (or pry with a toothpick and insert a credit card or guitar pick under the corner to maintain separation).

Do not leave the hairdryer on the screen protector for much longer otherwise, it might warp and make it more difficult to remove. Go slowly, as you don't want to rush the job and tear your screen protector into pieces. If your phone screen is wider than the tape, repeat the process to cover the second part of the screen. If you can't find a way in and the screen protector is firmly attached to the display at the corners, you can try duct tape.

After blowing hot air, select one of the corners of the screen protector and carefully separate it until all the protector is removed. It is okay to overlap the tapes. This will help to loosen the adhesive which holds the screen protector in place. Tear off a piece of duct tape.

It does not affect or prevent the broken screen protector from functioning properly. Be careful not to overheat the device, as this could damage it. Cut off a few pieces of tape and loop them into rolls with the adhesive side out. So, as you remove it, whether with a thin paper or blade, make sure you put more force towards the side of the glass protector and not your phone’s display.

As you are drying your screen protector, new dust particles may fall onto it. With the sticky side facing out, roll the tape around two fingers. Invert the screen protector and stick it to the table so that it is anchored firmly in place. Once a corner is loosened, use your fingers to gently pull it up and away from the phone.

Remove screen protector from your phone using hair dryer. Train a hairdryer on the screen at the low setting for about 15 seconds. Alternatively, you can also use your fingernails if you have long nails, that is! Do this by placing the duct tape on the corner of the screen.

Start blowing hot air over the screen protector of your mobile. Try your best to keep the protector as even as possible so it doesn’t bend and break. Use your fingernail to pry up a corner of the screen protector. This step will help remove any finger print stains and dust particles that are stuck.

Place a strip of scotch tape across your screen and lightly press down to adhere to it.